If your printer cannot handle spooling such a large printload at once as may well be the case, try printing only a few pages at a time. For example, print only pages 1-5 or 1-10, then the next 5 or 10, and so on until you have it all.

Prints fine for me, so I'm not sure what to tell you. It could well be an issue with Adobe 8, or something else. I use 7 myself with no issue at all.

I am also having some weird problems. At home to my Xerox Phaser 6120, it was printing one page at a time really slow. So I took the file to my office, and it drove the printer (a hefty Canon iR6000) nuts, freezing it until I rebooted the printer.

I'm using Adobe 6.

-HM

Some additional information...I updated to Adobe 8 and attempted to print just page 1. When it was spooling out to the printer, the file size, according to the printer status window, kept creeping up until it was past 100 MB. And it still wasn't done sending to the printer.

This is undoubtedly why the thing never prints for me - the printer is taking too long to crunch something of that size.

-HM

I never figured out why my office printer wouldn't crunch the file. I sucked it up and printed the manual, albeit slowly, on my home printer. At least it worked.

For the record, it appears that Adobe Reader 7 makes much smaller spool files than Reader 8. Go figure.

On a completely side note, it didn't seem that the new manual explained anywhere how you can focus attention on research, industry, or military output by clicking on one of the three appropriate spots on the top of the planet management screen. I know it's in the original GalCiv2 manual, so maybe I'm just missing it.

-HM